User manual

1. Turn the screen towards yourself so that the driver card opening sits at the top of the VDO key.

2. Turn on the VDO key on the button at the bottom and the screen will be lit.

3. Insert the driver card into the opening there, with the chip at the bottom and towards yourself

4. Data download begins while on the screen you can see a horizontal bar loading.

5. The VDO key beeps when data download is complete.

6. Remove the driver card and turn off the VDO key on the button.

1. Turn on the VDO key on the button and the screen will light up.

2. Make sure the vehicle engine is on.

3. Put company cards in slot 2 tachograph with the chip at the bottom and towards yourself.

4. Take the triangular cap of the VDO key, which sits on the left if the card opening is at the top and the button at the bottom.

5. Insert the VDO key into the tachograph opening.

6. Data download starts while VDO key diode flashes

7. When download is complete, the VDO key beeps while the diode lights up permanently

1. Take the square cap of the VDO key, which sits on the right, if the card reader is at the top and the button at the bottom.

2. Install the VDO key in the USB connector if necessary. Note: Important that the VDO key is turned off!

3. Insert the other end of the cord or key USB into the VDO Download Terminal USB input on the right side.

4. Download begins and the VDO key beeps when it is finished. The screen will say: Download Complete.

1. Take the square cap of the VDO key, which sits on the right, if the card reader is at the top and the button at the bottom.

2. Install the VDO key in the USB connector if necessary. Note: Important that the VDO key is turned off!

3. Insert the other end of the cord into a USB input into your computer. Alternatively set the USB of the key directly in pc.

4. Download begins and the VDO key beeps when it is finished.

5. You can check if data has gone through by opening the Backup folder.